2008 Chevy Impala Key Fob Programming

Insert the original already programmed key in the ignition and start the engine.

2008 chevy impala key fob programming. Whether the system was installed with the car or purchased as an aftermarket option you can program or reprogram your remote in just minutes from the car. Press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. Keyless entry fob remote programming for all vehicles. Chevrolet automotive remote programming instructions.

A chime will sound indicating that the remote is programmed. Free keyless fob procedures for your new or used replacement fob. To program additional remotes at this time repeat step 4. Turn ignition to the on position for 5 seconds then back to off position.

2008 chevrolet impala we strive to provide convenience to our customers with free keyless entry remote fob programming instructions for every single vehicle that we sell on northcoast keyless. Remove the existing key and within 5 seconds insert new key and turn it to the on position for 5 seconds. This vehicle can have a maximum of eight remotes programmed. Start vehicle to test key.

Turn key off then back to on. 2011 up vehicles require dealer or locksmith programming only. Press the set reset button until remote key learning active displays press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. 2008 chevrolet impala remote programming there are 2 possible procedures for this gm vehicle note.

Yes once you have had the new key cut by a locksmith use the following instructions. 2008 chevrolet impala key programming 1. The chevrolet impala has been manufactured throughout the 1990s and 2000s and today offers drivers the keyless entry remote system. Remove the existing key and within 5 seconds insert new key and turn it to the on position for 5 seconds.

The instructions will not work for 2011 up vehicles. Insert an existing programmed working key into the ignition cylinder. Insert an existing programmed working key into the ignition cylinder. A chime will sound indicating that the remote is programmed.